Worcester MT10RF Instruction Manual download pdf (Page 7)

5

TRANSMITTER RADIO LINK

& SETUP LOCATION

FITTING & OPERATING INSTRUCTIONS

8-716-107-486d (12.06)

1

2

3

4

5

6

7

8

9

1

0

1

1

1

2

1

3

1

4

1

5

1

6

1

7

1

8

1

9

2

0

2

1

2

2

2

3

2

4

OVERRIDE

override

1.5m (5)

INSTALLATION &

COMMISSIONING

TRANSMITTER RADIO

LINK SETUP & LOCATION

Radio Link setup:

First remove the transmitter baseplate:

1

Locate a flat bladed screwdriver

into the slots in the baseplate (B), as

shown and twist to lift the transmitter

top (A) away from the baseplate (B).

Establishing a radio link:

2

Press and hold button (C) down

on the receiver for approximately 5

seconds to the enter setup mode

with the LED (D) continuously on.

The receiver is now ready to accept

a setup signal from the transmitter

for up to 2 minutes.

3

Fit the batteries (E) correctly into

the battery compartment (F) to enable

the transmitter to send a setup signal

to the receiver.

When a radio link has been established

the LED briefly flashes twice and

extinguishes. This link then remains in

the event of a power loss.

However, if a radio link has not been

established, remove the batteries from

the transmitter and wait 10 seconds

before repeating the setup procedure.

Transmitter Location:

4

Position the transmitter (A) as close

to the main living area as possible on

an inside wall, approx. 1.5m (5') above

the floor within the max. signal range

of the appliance receiver.

Keep the transmitter away from:

 light and heat sources

 enclosures and curtains

 direct draughts, including fans, air

vents, windows and doors

 damp and condensation.

1

A

B

2

3

A

C

E

D

4

F

A

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments